Garmin GNS 430 - Assembly Drawings; Introduction; Drawing List

400 SERIES MAINTENANCE MANUAL Page 7-1
P/N 190-00140-05 Rev. C
SECTION 7
ASSEMBLY DRAWINGS
7.1 INTRODUCTION
This section contains assembly drawings to aid in assembly and disassembly of the 400 Series
units. Part numbers and drawing notes can be used as reference information during disassembly
and assembly. Note: The revision levels of the drawings are current at the time of manual
publication and are subject to change without notice.
7.2 DRAWING LIST
The following drawings are included in this section:
GNS 430:
x Figure 7-1—Sub-Assembly, GNS 430 (Dwg. No. 015-00280-XX, Rev. P)
x Figure 7-2—Main Chassis Assembly, GNS 430(A) (Dwg. No. 015-00283-00, Rev. R)
x Figure 7-3—Nav Chassis Assembly, GNC 400 (Dwg. No. 015-00282-00, Rev. K)
x Figure 7-4GNC 4XX CDU Assembly (Sheet 1 of 2) (Dwg. No. 015-00281-XX, Rev. F)
x Figure 7-4GNC 4XX CDU Assembly (Sheet 2 of 2) (Dwg. No. 015-00281-XX, Rev. F)
GNS 430A:
Use the GNS 430 Figures for the GNS 430A.
GNC 420:
x Figure 7-5—Sub-Assembly, GNC 420 (Dwg. No. 015-00506-XX, Rev. N)
x Figure 7-6—Main Chassis Assembly, GNC 420(A) (Dwg. No. 015-00283-01, Rev. K )
x Figure 7-7—Sub-Assy, GNC 420 Nav Chassis, W/O Nav (Dwg. No. 015-00282-01, Rev. E )
x GNC 420 CDU Assembly Drawing (Use Figure 7-4)
GNC 420A:
x Figure 7-8—Sub-Assy, GNC 420A (Dwg. No. 015-00837-XX, Rev. A )
x Main Chassis Assembly, GNC 420A (Use Figure 7-6)
x Sub-Assy, GNC 420 Nav Chassis, W/O Nav (Use Figure 7-7)
x GNC 420A CDU Assembly Drawing (Use Figure 7-4)