To Next PageTo Next PageWhat causes Garmin tuning data not updating DME and how to solve it?
If the tuning data isn't updating the DME, it could be due to: * Incorrect configuration: Check the DME Channel Mode on the VOR/LOC/GS CDI page. * Wiring: Check wiring.
What does Garmin basemap database integrity error mean and how to fix it?
A “Basemap database integrity error” message on your 400W Series unit indicates a failure in the built-in basemap (land data) database. To resolve this, reload the basemap database.
Why Garmin 400W Series GPS unit is not receiving heading from compass system?
If your 400W Series unit isn't receiving heading from the compass system (when using ARINC 429 heading input), it might be due to: * Incorrect ARINC 429 input port speed: Check the ARINC 429 input port speed setting for the port that the device is connected to and verify that the speed is correct for that device. * Wiring: Check wiring.
How to resolve Garmin data transfer cancelled (version mismatch) error?
A “Data transfer cancelled (version mismatch)” error during a unit-to-unit crossfill indicates that the database versions on the two 400W Series units aren't identical. Update the databases so they match.
How to fix Garmin CDI scaling on EFS 40/50 that is not correct?
If the CDI scaling on your EFS 40/50 is incorrect, it may be because the FMS #1/#2 configuration is not set to “KLN 90-GPS”. Reconfigure EFS 40/50 for “KLN 90-GPS” on FMS #1/#2 inputs, as appropriate.
What to do if Garmin data transfer cancelled (data invalid)?
A “Data transfer cancelled (data invalid)” error during a unit-to-unit crossfill means that an attempt to transfer a single user waypoint was cancelled because no waypoint was specified on the Crossfill Page. Select a user waypoint and re-attempt the transfer.
What causes Garmin RMI pointer to not indicate correctly?
If the RMI pointer isn't indicating correctly, the desired RMI source might not be selected. Check the OBI source selection on the Main CDI/OBS Config page.
How to resolve Garmin user card format unknown error?
If your device displays a “User card format unknown” error, it means a data card has been inserted, but the format of the card isn't recognized. Try reloading the information onto the card; if that doesn't solve the problem, replace the card.
General| Display | 5.0" diagonal, 256 colors TFT |
|---|---|
| Resolution | 320 x 234 pixels |
| WAAS | Yes |
| Operating Temperature | -20°C to +55°C |
| Update Rate | 1 Hz |
| Database | Jeppesen |
| COM Frequency Range | 118.000 to 136.975 MHz |
| COM Channel Spacing | 25 kHz |
| NAV Frequency Range | 108.00 - 117.95 MHz |
