c510 Owner’s Manual 29
aPPendix
Troubleshooting
Problem/Question Solution/Answer
My c510 never gets
satellite signals.
Take your c510 outside, away from tall buildings and trees.
Remain stationary for several minutes.
How do I know my c510
is in USB Mass Storage
Mode?
When your c510 is in USB Mass Storage Mode, a picture of a
c510 connected to a computer is shown. Also, you should see
two new removable disk drives listed in My Computer.
My computer never
senses that the c510 is
connected.
1. Unplug the USB cable from your computer.
2. Turn the c510 off.
3. Plug the USB cable into your computer and your c510.
The c510 automatically turns on and goes into USB Mass
Storage Mode.
I cannot see any new
removable drives in my
list of drives.
If you have several network drives mapped on your computer,
Windows may have trouble assigning drive letters to your c510
drives. Follow the steps on the next page to assign (map) your
drive letters.
I get a message saying
“Unsafe Removal of
Device” when I unplug
the USB cable.
When you are ready to disconnect your c510 from your
computer, double-click the Unplug or Eject icon in your
system tray. Select USB Mass Storage Device, and click Stop.
Select the c510 drives, and click OK. You can disconnect your
c510 from your computer now.
To Next Page
Loading...
Need help?
General
