5
Installation
Installing a Data Card in the
Programmer
To Install a Garmin Data Card:
1. Insert the Data Card (Label up and pin connector end fi rst) into the
card slot in the Programmer (standard USB Programmer pictured
to the right).
For the Mini-USB Programmer, make sure the Garmin
globe logo on the Programmer is facing UP for proper
orientation.
2. Be certain to install the Data Card completely into the slot to be
sure the pin connections have been made.
3. To remove the Data Card, pull directly away from the Programmer
using the extractor handle on the Data Card.
Use care not to remove the Data Card from the Program-
mer until data transfer has been completed to avoid pos-
sible loss of data.
Disconnecting the Programmer from Your Computer
After the USB Data Card Programmer has been successfully
installed (hardware and software), disconnecting and reconnecting the
Programmer can performed without additional installation steps.
1. Before disconnecting the Programmer, be certain that no data
transfer is in progress.
2. Unplug the USB connector from your computer. You do not need
to turn the computer off before removing or inserting the USB
connector.
Extractor Handle
Disconnecting the Programmer
from Your Computer
,
,
USB DCP Manual.indd 5 12/18/2002, 4:14:39 PM
To Next Page
Loading...
Need help?
General