Garmin USB Data Card Programmer User Manual

i
Introduction
Thank you for choosing the Garmin
®
USB Data Card Programmer
or the Garmin StreetPilot
®
III with Mini-USB Data Card Programmer.
To get successful results from your new USB Data Card Programmer,
take time to read through this user’s manual in order to fully under-
stand all of the operating procedures.
This manual is organized into three sections:
The Introduction section provides licensing agreement informa-
tion and a description of the programmer.
The Installation section introduces you to basic features and
procedures for programmer setup.
The Trouble Shooting section contains information for fi nding
solutions to installation and operating problems.
Standard Package Contents (USB Data Card Programmer)
• USB Data Card Programmer
• CD-ROM with USB Device Drivers for Windows 98/ME,
2000, and Garmin MapSource
TM
Upgrade Software including
USB Support. (The USB drivers are also on the MapSource
City Navigator CD-ROM or MapSource Setup CD-ROM, if
applicable.)
• User’s Manual
• MapSource User’s Manual Addendum for the USB Data Card
Programmer
About This Manual
Minimum System Requirements
IBM-Compatible PC with Pentium processor, 16
Megabytes RAM, CD-ROM drive, Mouse or other
pointing device, 256-color display adapter (24-bit
color recommended) and monitor with 640 x 480
resolution or higher, and up to 20 Megabytes free
hard drive space. A 32 bit operating system such
as Windows 98/ME, Windows 2000, or Windows
XP. Universal Serial Bus port (USB). The USB Data
Card Programmer is not designed to operate with
Windows 95 or Windows NT.
Software Requirements
Existing installation of Garmin MapSource
upgraded to Version 3.04 or later.
USB DCP Manual.indd i 12/18/2002, 4:14:33 PM

Garmin USB Data Card Programmer Specifications

General

Brand	Garmin
Model	USB Data Card Programmer
Category	GPS
Language	English