EasyManuals Logo

GAS GAS MC 450F 2021 User Manual

GAS GAS MC 450F 2021
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
18 CLEANING, CARE
112
18.1 Cleaning the motorcycle
Note
Material damageComponents become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance 60 cm (23.6 in)
Note
Environmental hazardHazardous substances cause environmental damage.
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-
cable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
Close off exhaust system to keep water from entering.
Remove loose dirt first with a soft jet of water.
Spray the heavily soiled parts with a normal commercial motorcycle
cleaner and clean using a brush.
Motorcycle cleaner ( p. 131)
Info
Use warm water containing normal motorcycle cleaner and
a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always
rinse the vehicle with water first.
After rinsing the motorcycle with a gentle spray of water, allow it to
dry thoroughly.
Remove the closure of the exhaust system.
Warning
Danger of accidentsMoisture and dirt impair the brake
system.
Brake carefully several times to dry out and remove dirt
from the brake linings and the brake discs.
After cleaning, ride the vehicle a short distance until the engine
warms up.
Info
The heat produced causes water at inaccessible locations in
the engine and on the brake system to evaporate.
Push back the protection caps of the handlebar controls to allow any
water that has penetrated to evaporate.
After the motorcycle has cooled down, lubricate all moving parts
and pivot points.
Clean the chain. ( p. 66)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GAS GAS MC 450F 2021 and is the answer not in the manual?

GAS GAS MC 450F 2021 Specifications

General IconGeneral
BrandGAS GAS
ModelMC 450F 2021
CategoryMotorcycle
LanguageEnglish

Related product manuals