CLEANING, CARE 17
103
17.1 Cleaning the motorcycle
Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
– Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
– Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance 60 cm (23.6 in)
Note
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-
cable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
– Close off exhaust system to keep water from entering.
– Remove loose dirt first with a soft jet of water.
– Spray the heavily soiled parts with a normal commercial motorcycle
cleaner and clean using a brush.
Motorcycle cleaner ( p. 119)
Info
Use warm water containing normal motorcycle cleaner and
a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always
rinse the vehicle with water first.
– After rinsing the motorcycle with a gentle spray of water, allow it to
dry thoroughly.
– Remove the closure of the exhaust system.
–
Empty the carburetor float chamber. ( p. 97)
Warning
Danger of accidents Moisture and dirt impair the brake
system.
– Explain to your child that he or she must brake carefully
several times to dry out and remove dirt from the brake
linings and the brake discs.
– After cleaning, let your child ride the vehicle a short distance until
the engine warms up and the brakes have dried due to careful appli-
cation of the brakes.
Info
The heat produced causes water at inaccessible locations in
the engine and on the brake system to evaporate.
– Push back the protection caps on the handlebar controls to allow
water to evaporate.
To Next Page
Loading...
Need help?
General
