Need help?Do you have a question about the Gate NanoHARD and is the answer not in the manual?
General| Brand | Gate |
|---|---|
| Model | NanoHARD |
| Category | Controller |
| Language | English |
Directs energy to the motor, bypassing contacts for higher ROF and faster response. Protects contacts.
Protects LiPoly batteries from over-discharge by monitoring voltage and preventing firing below critical levels.
Ensures compatibility with micro-switches, resistant to contact bounce for better ROF and MOSFET longevity.
Utilizes modern transistors and microcontrollers for a compact and reliable AEG controller.
Supports batteries up to 14.8V Li-Po, with minimum operating voltage 3V and maximum 17V.
Modifies original wiring by de-soldering wire A and soldering to wire B, then adding a signal wire.
Replaces existing AEG wiring with high-quality, low-resistance wiring and connects motor directly to NanoHARD.
Guides through setting Battery Protection and Active Brake modes using a jumper and button.
Outlines the connection steps using a jumper and battery to enter the diagnostic mode.
Explains how to interpret DTCs by counting LED flashes and matching them to specific error codes.
Provides detailed explanations for each DTC, including potential causes and troubleshooting steps.
To Next Page
