Gate NanoHARD User Manual

15
WWW.GATEE.EU
USER GUIDE
05. Diagnostic Trouble Codes - interpretation
If you have a problem with your AEG, the Diagnostic Trouble Codes can help you
verify where the problem lies. Please note that the DTC signalize a problem with
your AEG or battery, not with your NanoHARD.
To diagnose the current problem, remember to clear the old DTC that are stored in
NanoHARD memory (p.15). Then try to shoot your gun. Now, only the current DTC
are stored in memory.
None
DTC
There is no Trouble Code.
Low voltage Please check:
1) if the battery is charged,
2) if the battery protection is set correctly (p.12),
3) if your AEG works with another battery. The battery may
be damaged.
Low voltage HR
(high resistance)
Please check:
1) if the battery is charged,
2) if the battery connector is damaged,
3) if your AEG works with another battery. The battery may
be damaged.
Current too high
Please check:
1) if your motor is shorted (damaged),
2) if your motor is jammed,
3) if there is a short circuit in your AEG installation.
Temperature
too high
Please check:
1) if there is a short circuit in your AEG installation,
2) if your motor is damaged.
Step 7A. Exit
Click!
Step 7B. Clear DTC and Exit
Click & HOLD!

Gate NanoHARD Specifications

General

Brand	Gate
Model	NanoHARD
Category	Controller
Language	English