Gate NanoHARD - Page 11

11
WWW.GATEE.EU
USER GUIDE
Step 3. Connect BATTERY to NanoHARD.
Step 4. When is OFF, NanoHARD. blue LED disconnect JUMPER from
BATTERY
UP TO 14.8V
uC
Blue LED
starts blinking
uC
Blue LED
OFF
BATTERY
UP TO 14.8V
IMPORTANT
If you disconnect JUMPER when the is ON,
go back to Step 1
blue LED
Step 5. You are in programming mode. Connect the BUTTON included in the kit to NanoHARD.
uC
BATTERY
UP TO 14.8V
Blue LED
is blinking
FUSE
FUSE
FUSE