Entering a password to get to User or Engineer’s menus
To protect system parameters from being altered by unauthorised people. Two passwords
have to be entered to gain access to available menus which allow changes to be made.
The first 4 button password is the USER menu and gives access to a limited set of menus,
E.g. clock set, LED test etc. The second 4 button password is for the ENGINEER’S menu
which gives access to all menus including the users. A sequence of 4 buttons is accepted as
the entry for a password.
To start the entry of the password, press SELECT (3).
The password display is shown on the LCD and each of the 4 buttons in sequence can now
be pressed.
Default Passwords
The USER password is defaulted to DOWN (5) pressed 4 times.
The ENGINEERʼS password is defaulted to + (4) pressed 4 times. (or as per customer
requirement)
Changing the engineers password is described later.
The user password cannot be changed.
Combi System Menu Index
See Appendix 1 for further details.
Note: User menu only contains items shown in red. Engineer's menu contains all items.
1 View Modbus Reg
2 Set Clock
3 Inhibit all Sensors
4 View Modbus txrx
5 Refresh Rate
6 Edit Company Text
7 Lamp Test
8 Relay Test
9 Event Log to LCD
10 Add zero/span
11 LCD Led Bright
12 Exit
13 Top of Engineers
14 Inhibit Sensor
15 Add Alarm Levels
16 Clear All Addresses
17 Alter Chan Text
18 Alter Gas Type and Range
19 View Add sensor status
20 4-20mA Zero Span
21 4-20mA Alarm Levels
22 Unlatched Alarms
23 Event to Relay64
24 Relay off Timers
25 Channel Voting
26 Seconds to Alarm
27 Setup Network
28 Event log to PC
29 Data PC to Panel
30 Data Panel to PC
31 Ltel Stel Alarm
32 Default Sections
33 Engineer Password
34 Set Modbus Baud
35 Set Power Alarms
35 Set Power Alarm
36 Energised Relays
8
To Next Page
Loading...
