GE Security Concord 4 User Manual

For a detailed review of the entire system, please view the Concord 4 system manual.
Arm and Disarm
Arm:
 To arm all sensors in AWAY mode when you are leaving the premises, press [3] and enter your
[security code].
 To arm all sensors in STAY mode when you are not leaving the premises, press [2] and enter your
[security code].
Disarm:
 To disarm, enter your [security code] + [1].
Quick Guide: GE Security Concord 4

GE Security Concord 4 Specifications

General

Zones	Up to 48 zones
Keypad	Supports multiple keypads
Partitions	Up to 8 partitions
Wireless Frequency	319.5 MHz
Compatibility	GE Security and Interlogix devices
Communication	IP communication
Power Supply	16.5VAC
Battery Backup	12VDC
Compatible Devices	GE Security and Interlogix sensors, keypads, and modules
Programming	Via keypad or software
Communication Type	POTS, cellular, or IP
Type	Hybrid Wireless/Hardwired Security System

Summary

Arm and Disarm

Arm

Instructions on how to arm the system in AWAY or STAY mode using security codes.

Disarm

Instructions on how to disarm the system using a security code.

Battery

Bypassing Protected Areas

To bypass a zone directly

Steps to bypass a zone directly by entering the sensor number and security code.

To bypass a zone indirectly

Steps to bypass a zone indirectly by leaving zones open and arming the system.

To unbypass a zone

Instructions to unbypass previously bypassed zones.

Change Time and Date

To change the system date

Procedure to set the system's date using master code and security codes.

To change the system time

Procedure to set the system's time using master code and security codes.

Chimes and Beeps

Reset

Security Codes

To add a new user

Steps to add a new user with a 4-digit code and specific attributes.

To delete a user

Steps to delete an existing user from the system.

Trouble Conditions

Volume