GE 28821FE1 - Page; Handset to Handset Paging; Paging All Handsets from a Handset; Paging from the Base;Group Page

8

The page feature helps you locate a misplaced handset. To send and receive
pages, all handsets must be registered. If your handset is not registered, follow the
instructions in the Registration section of this manual.


1. Make sure the phone is (not in TALK mode).
. Press and release the delete/intercom/conf button on a handset. PAGING
EXTENSION? shows in the display.
. Use the touch-tone pad to enter the handset number you want to page.
. To cancel the page, press the END/cancel, delete/intercom/conf, or TALK button
on the originating handset, or press the END/cancel button on the receiving
handset.


1. Make sure the originating phone is (not in TALK mode).
. Press and release the delete/intercom/conf button on a handset. PAGING
EXTENSION? shows in the display.
. Use the touch-tone pad to enter the handset number you want to page. (1= to
page Handset 1, =to page handset , etc., and * tone=to page all handsets)
. To cancel the page, press the END/cancel, delete/intercom/conf, or TALK button
on the originating handset, or press the END/cancel button on the receiving
handset.

Use the base-only to page all registered handsets at the same time.
1. Press the nd button on the base. All handsets beep for two minutes, and PAGING
FROM BASE shows on each handset’s display.
. To cancel the page, press the nd button on the base, or press the TALK button or
the END/cancel button on each handset.