Positioning the Unit
WARNING:
Never position the unit where it could fall and injure a patient or caregiver.
WARNING:
When handling the fiberoptic cable connector (during insertion, removal or
positioning of the fiberoptic light pad) use caution to prevent the fiberoptic
cable connector from dropping, which can damage the fiberoptic cable
connector and/or injure the patient or caregiver.
CAUTION:
Never position the unit where it could interfere with the performance of other
equipment, e.g. opening the hood of the Giraffe
®
OmniBed, preventing the side
panels from opening in Infant Warmer Systems, etc.
The following options are available to position the BiliSoft LED Phototherapy system:
• On a shelf or other stable, flat surface (no additional mounting bracket required)
• On the Ohmeda Medical Dovetail Rail (mounting brackets sold separately)
• On the Ohmeda Medical Mobile Stand or Giraffe Spot PT Lite Roll Stand (mounting
brackets and stands sold separately)
The BiliSoft mounting bracket (sold separately) allows the BiliSoft LED Phototherapy System to
be mounted to an Ohmeda dovetail rail, Ohmeda mobile stand, or Giraffe Spot PT Lite roll
stand. Attach the male mounting bracket accessory to the four holes at the bottom of the
main unit using the hardware provided with the bracket. For added convenience, the bracket
can be positioned on the left or right side of the unit. See the accessory parts list in this
manual for relevant stock numbers.
Note: Due to manufacturing tolerances in the mounting bracket and the receptacle, a small
amount of tilt may be noticed in the unit.
Note: To avoid damage to the BiliSoft unit, use care when the BiliSoft is attached to other
equipment that is being transported to ensure that the unit is protected from impacting door
jambs or any other obstacles.
M1110147 Rev. 5 © 2007 Datex-Ohmeda. All rights reserved. 5-3
To Next Page
Loading...
Need help?
General
