Image Plate Details
The structure of the image plates is as follows:
0,6 mm
1 Top layer / protective coating: Blue (IPU) or white (IPS / IPS2 / IPC2)
2 Phosphor layer
3 Adhesive layer
4 PET support
5 Adhesive layer
6 Ferromagnetic layer
7 Bottom layer / protective coating: Gray*
* The bottom side looks gray, as the ferromagnetic layer is gray, and the protective coating is transparent.
NOTE: The top layer (blue or white) is facing towards the radiation source and
needs to be on top when inserting the image plate in the CRxVision for
scanning.
Recommended application range per image plate type:
Image plate type Characteristics Application
IPU for CRxVision
Small particle size Phosphor.
Blue pigment in Phosphor layer and
topcoat.
High resolution imaging
IPS for CRxVision
Small particle size Phosphor.
Coated topcoat.
Medium resolution imaging
IPS2 for CRxVision
Small particle size Phosphor.
Coated topcoat.
Medium resolution imaging
IPC2 for CRxVision
Large particle size Phosphor.
Screen printed topcoat.
Medium resolution imaging
For detailed application support and image plat selection guidance please contact your
technical sales representative.
NOTE: Each image plate has an IPF (2 digits) and IPS (4 digits) value printed
on the back side of the image plate. These values represent the sensitivity of
this specific image plate.
12 CRxVision Operating Manual V1.2
To Next Page
