Need help?Do you have a question about the GE Druck DPI 620 and is the answer not in the manual?
General| Measurement Parameters | Pressure, electrical, temperature |
|---|---|
| IP Rating | IP54 |
| HART Communication | Yes |
| Temperature Measurement | RTD, Thermocouple |
| Display | Color |
| Communication Interfaces | USB |
| Operating Temperature | -10°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Loop Power | 24 V |
Information on the Li-Polymer battery, its condition, installation, charging, and operating time.
Overview of the instrument's menu structure, including configuration, status, and task selection.
Procedures for setting up measure and source functions, including process and automation options.
Access to advanced settings like HART resistor, standards, calibration, and setup files.
Steps for calibrating the instrument and changing the calibration PIN.
Procedures for measuring and sourcing electrical values, including current, voltage, and frequency.
Instructions for assembling and using an IDOS module to measure pressure.
Procedures for making pressure connections using quick-fit adaptors and proper sealing.
Steps to set up and perform pressure measurements, including leak tests and zeroing the module.
Step-by-step guide for connecting the DPI 620 to a computer using a USB mini Type B cable.
Steps to perform data logging, including task selection, filename, trigger, and start.
How to compare data from two channels, calculate errors, and get pass/fail indications.
Steps to start HART device search and initiate communications.
To Next Page
