[EN] English - K0449 Instrument communications 5-1
Chapter 5: Instrument
communications
5.1 Introduction
This chapter gives a description of these items:
• the procedures to connect the instrument to a computer with
the optional USB mini Type B cable
For a full list of optional accessories, refer to Section 1.4.
5.2 Connect to a
computer (USB)
You can use the USB mini Type B connector to connect the
instrument to a computer. To download or upload data to the
micro SD card or USB flash memory device, see Chapter 6
(Datalog operation).
Note: If the power supply fails, the data will not transmit
correctly. To prevent loss of data, use the DC power supply
(Section 2.6).
When the connections are complete you can move files
between the computer and the DPI 620 calibrator with your
normal file manager software (for example, Windows Explorer).
If you install a USB flash memory device and a micro SD card,
the computer can only see the micro SD card. It ignores the
USB memory device.
Note: The computer cannot get access to the internal memory
of the DPI 620 calibrator.
1
2
4
5
3
Step Procedure
1. Start the computer.
2. Push the Type A end of the USB cable into a USB
socket on your computer.
3. On the right-hand side of the instrument
(Figure 1-3), use the rubber recess to pull down
the cover for the connections.
4. Attach the DC power supply (Section 2.6).
5. Push the mini Type B end of the USB cable into
the USB socket on the instrument.
6. Set the instrument power on.
To Next Page
Loading...
