Need help?Do you have a question about the GE Druck DPI 615 IS and is the answer not in the manual?
General| Brand | GE |
|---|---|
| Model | Druck DPI 615 IS |
| Category | Test Equipment |
| Language | English |
Safety advice regarding pressure limits for instrument operation.
Details requirements for using the instrument in hazardous areas.
Outlines specific safety requirements for instrument operation.
Details safe working pressure limits and measurement accuracy.
Instructions for installing batteries and powering on the instrument.
How to select and use different test tasks from the menu.
Details on BASIC, ADVANCED, and Cal Mode operations.
Lists various measurement tasks like P-I, P-V, P-P, etc.
Summary of Tare, Max/Min, Filter, Flow, and % Span functions.
Saving, storing, and recalling data logs and snapshots.
Adjusting units, language, RS232, powerdown, and calibration.
Procedures for using, draining, and flushing the hydraulic system.
Instructions for fitting specified batteries safely.
Steps to switch on the instrument and initial display modes.
How to select tasks using the TASK key and cursor keys.
Setting up and using Cal Mode for DPI 615 instruments.
Instructions for P-I and P-V transmitter measurement tasks.
Procedure for P-P task to measure converter output.
Instructions for I-P converter and P-SWITCH test tasks.
Procedure for P-DISPLAY task using Data Log.
How to set up and perform a leak test.
Procedure for TX SIM task to simulate transmitter output.
Steps for performing a relief valve test.
Summary of Tare, Max/Min, Filter, Flow, and % Span functions.
How to set up and use the Tare function for readings.
Setting up display for min/max and present input readings.
Applying a low pass filter to a selected input.
Applying the square root function for flow measurement.
Converting readings to percentage of full-scale.
Setting up and running mA step output programs.
Defining and running mA ramp output programs.
Adjusting output current level using mA Value.
Overview of calibration, period, and technician requirements.
Steps for performing calibration checks and adjustments.
To Next Page