K0430 Issue No. 2 vi
Introduction
General
Description of Procedures 1
Summary of Functions
Using this Guide 2
OPERATOR CONTROLS 3
DISPLAY 3
HARD KEY FUNCTIONS 4
SOFT KEYS 5
CURSOR KEYS 5
ELECTRICAL CONNECTIONS 6
Getting Started
Fitting Batteries 7
Switching On 7
Change Pressure Units 8
Voltage and Current Measurement 8
Typical Calibration Set-up (Pressure to Voltage) 9
Zero Display Reading 9
Task Selection
Task Key 10
Using Task Functions 10
Set Units 10
Cal Mode (DPI 615 instruments only) 11
Basic Mode (Task BASIC) 11
Taking Measurements
Pressure Transmitter (P-I) Task 12
Voltage Output Pressure Transmitter (P-V) Task 12
Pressure Converter (P-P) Task 13
Current to Pressure Converter (I-P) Task 14
Pressure Switch Test (P-Switch) Task 14
Pressure to Display (P-Display) Task 15
Leak Test (Leak Test) Task 16
Transmitter Simulator (TX SIM) Task 17
Relief Valve Test (REL VALVE) Task 18
To Next Page
Loading...
