DPI 740 User Manual 43
K0200 Issue No. 1
6.3Command Summary
The following functions can be performed using the serial link:
Input Commands
IC=<param type> Set-up input
IR? Get input reading
IU=<index> Set-up input units
IA=k Enable automatic sending of input
reading
Process Commands
PC =<process definition> Set-up Process
PC =~(IR),<value>,<value> filter
PC =T(IR) tare
PC =T(IR),<value>
PC =<(IR) maximum
PC =>(IR) minimum
PC =Q(IR),<value>,<value> QFF
PC =A(IR),<value> altitude
PR ? Get process reading
PA =k Enable automatic sending of process
reading
PM Reset process maximum and minimum
values
Instrument Set-up Commands
SA=<nn> Set instrument address
SUn=<units index> Set-up regular units
Calibration Commands
CT=<cal type> Specify calibration type
CP=<value>[,<temperature>] Enter calibration point
CN? Get no. of calibration points reqd.
CA Calibration accept
CX Calibration abort
CD Calibration date
To Next Page
Loading...