– 25 –
(Continued next page)
Knob Index /
Test number
Displayed on
VHJPHQW
display (SSD)
Test Name
Description of test
Turning the cycle knob will index to the next or prior test.
8 Fabric Softener
Dispenser
Pressing Start will toggle the fabric softener valve on and off.
Test will have a time-out for how long valve will be on (1 minute).
The valve will turn off when the test is exited.
9 Spray Rinse
Valve Check
Pressing Start will toggle the spray rinse valve on and off. Test
will have a time-out for how long valve will be on (1 minute). The
valve will turn off when the test is exited.
10 Pressure Sensor Pressing Start will start the test.
Pressure sensor test will have a time-out.
All valves will turn on.
All LEDs will blink at start of test.
Stop blinking LEDs as approximate water levels are crossed.
The approximate levels are:
2"
3"
4"
5"
6"
7" - Water valves shuts off at this level.
11 Recirculate Pump Pressing Start will toggle the recirculation pump on and off.
Test will have a (1 minute) time-out for how long recirculation
pump will be on.
The recirculation pump will turn off when the test is exited.
12 Drain Pump Pressing Start will toggle the drain pump on and off. Test will
have a (4 minute) time-out for how long drain pump will be on.
The drain pump will turn off when the test is exited.
13 Lid Switch Pressing Start will start the test.
When the lid is open, the Spin status LED will blink. When the lid
is closed, the Rinse status LED will blink.
14 Spin Pressing Start will start the test.
Spin test will perform child safety algorithm before it starts to
spin. (Two sprays of water before locking the lid.) The lid must
be closed to start the test. If lid is open, the Locked LED will
blink.
When started, the mode shift to spin will occur if required and the
lid will be locked.
When mode shift is complete, the washer will begin spinning to
max spin speed for the model being tested.
Spin test will have a (4 minute) time-out.
Be sure to only run this test with an empty basket as there is no
OOB detection during this test.
The spin will stop when the test is exited. The lid will unlock once
the speed reaches 0 after the test is exited.
15 Agitate Pressing Start will start the test. Agitate test will perform child
safety algorithm before it starts to agitate. The lid must be closed
to start the test. If lid is open, the Locked LED will blink.
When started, the mode shifts to agitate will occur if required.
When mode shift is complete, the washer will begin agitating.
The test will pause if the lid is opened after starting. The test will
resume on lid close if it was running when opened.
The test will stop when the test is exited.
16 Clear all Fault
Codes
Pressing Start will clear all fault codes.
To Next Page
Loading...
Need help?
General
