GFK-2571A 3-1
Configuration
This chapter explains how to configure an RX3i PROFINET Controller and its I/O devices in a
PACSystems RX3i controller system. Additional information about RX3i configuration is available in
other PACSystems documentation and in the Logic Developer online help.
This chapter discusses the following topics:
▪ Configuration Overview
o Basic Configuration Steps
▪ Configuration Tools
▪ Configuring an RX3i PNC
o The PNC’s LAN
o Configuring PNC Parameters
▪ Configuring PROFINET LANs
o Configuring the LAN Properties
▪ Adding a VersaMax PROFINET Scanner to a LAN
o Configuring VersaMax PNS Parameters
o Adding VersaMax PNS Power Supplies
o Adding VersaMax Modules to a Remote Node
o Adding Power Supplies Between Modules
o Configuring VersaMax Module Parameters
o Configuring Analog Modules that have Jumpers
▪ Adding a Third-Party IO-Device to a LAN
o Editing Third-Party IO-Device Parameters
o Configuring Sub-modules of an IO-Device
▪ Viewing / Editing IO-Device Properties
▪ Assigning IO-Device Names
▪ Configuring IO-Devices
▪ After the Configuration is Stored to the RX3i CPU
o Clearing the RX3i Controller Configuration
To Next Page
Loading...
