GE Infinity S - Information: Controller Basic Operation; Accessing Controller Parameters; Controller Alarm Status and Clearing; Front Panel Controls

Infinity S (NE-S) Dual Voltage Power System – Quick Start Guide
8
Document 8600243957P Rev 2 Jan 2019
GE
Critical Power
8
Information: Controller Basic Operation
View and change system parameters from the factory defaults via
A) Controller Display
B) Craft Port on front of controller using a laptop with EasyView2 software or HyperTerminal.
EasyView2 (GUI) software can be downloaded from www.gecriticalpower.com,
C) J5 LAN port web pages using a laptop with browser. LAN port Server mode is for local laptop connection. Set the LAN
port to Server:
Controller Alarm Status: The display changes colors; Green = Normal, Amber = Minor Alarm, Red = Critical/Major Alarm
Some alarms may occur during initial installation; e.g. thermal probe fail or Major/Minor communication fail .
Clear these alarms: Via Controller Display: follow the menu path;
Menu > Control/Operation > Clear Events or Uninstall Equipment.
Verify Basic Installation Settings: Date, Time, Battery Type, number of strings and float voltage
Menu > Configuration > System Settings and Menu > Configuration > Batteries.
Front Panel
View and change system parameters from the factory defaults via the front panel:
Controller Front Panel Display and Controls
The main menu can be accessed using the Menu / Enter button
The basic menu structure for navigation is shown below:
Front Panel Menu Structure – Overview