GE Innova 2000 - Tools and Test Equipment for Installation

Innova 2000 Cardiovascular Imaging System
GE Medical Systems Pre–Installation Manual
REV 5 pim 2337741–100
163
3 TOOLS AND TEST EQUIPMENT
Refer to Table 30. To obtain a list of tools and test equipment for components not specified in
Table 30, refer to the appropriate component Pre-Installation Manual listed in Chapter 2.
Table 30 – INNOVA LC SYSTEM REQUIRED TOOLS AND TEST EQUIPMENT
PRODUCT OR
COMPONENT
TOOL OR
TEST EQUIPMENT
USED FOR SOURCE
RECEIVED
(DATE)
Innova LC Positioner Service Engineer’s
Tool Case
General Use 
Level, Protractor Type Positioner Checks 
Plumb Line included
in 46–216640G1
Positioner Checks 
Torque Wrench
2 to 20 daN.m
(15 ft. lbs. to 150 ft.
lbs.)
Positioner Checks 
1/2 inch Ratchet
Wrench (2)
Raise and Lower
Positioner shipping
dolly

Wrench, Spanner
(46–176584P1)
High Voltage Cable
Installation

Laptop Computer
(MS–DOS Windows)
Positioner Configura-
tion and Calibration

Status Display Same as for Innova LC
(Service Engineer’s Tool Case)
Omega IV Table Same as for Innova LC (Service Engineer’s Tool Case)
Fill in any additional tools or test equipment as required



POSTIT Cabinet Same as for Innova LC (Service Engineer’s Tool Case)
Fill in any additional tools or test equipment as required


X–Ray Head Same as for Innova LC (Service Engineer’s Tool Case)
Fill in any additional tools or test equipment as required


Control MPPU1 Same as for Innova LC (Service Engineer’s Tool Case)
Fill in any additional tools or test equipment as required


Power MPPU2 Same as for Innova LC (Service Engineer’s Tool Case)
Fill in any additional tools or test equipment as required

