EasyManua.ls Logo

GE Innova 3100-IQ - Run Interconnection Cables through the Conduit

GE Innova 3100-IQ
290 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5.3 Run Interconnection cables through the Conduit
Use the IVUS PIM (#806365003) as reference to the procedures below.
Unpack , and check the completeness of the Preinstallation kit :
1pcs - Custom PIM cable 30 m (98 ft, 5 in) - Volcano ID :806452001
2pcs - CAT5 cable 30 m (98 ft, 5 in) - Volcano ID :803391001
1pcs - Custom Twin axial cable - Volcano ID :806380001
1pcs – Ground Cable, 30 m (98 ft, 5 in) s5i – Volcano ID :806889001
1pcs - IVUS preinstallation Manual - Volcano ID :806365003
Install 806889001 Ground Cable through the Control Booth conduit (see note)
Install the cables through the IVUS conduit from the Control Room end :
806452001 Room - PIM cable, round shaped connector end to the Procedures
803391001 - Ethernet cable (1pcs)
Install the optional cables through the IVUS conduit from the Control Room end :
803391001 - Ethernet cable if 2 IVUS remote control items will be installed 1 IVUS Control
Station and 1 IVUS Joystick)
806380001 - ECG cable in case, if NON Mac-Lab ECG will be installed
NOTE: For the ground cable, see the IVUS service manual for special instructions
concerning cable running and cutting .
NOTE: If the installation has the MaC-Lab ECG in the configuration, the ECG cable
shall not be run through the conduit, it will be used in the Control Room to
connect Mac-Lab and IVUS PCs.
NOTE:
You should consider running the ECG cable through the conduit in case, the
customer requires interconnecting to a NON Mac-Lab ECG at the table base.
In this case you shall hide the unconnected cable in the conduit for future
expansion options.
NOTE: Same applies to the 2nd Ethernet cable, if a later extension of the IVUS remote
controls expected.
Ensure sufficient cable length on the Procedures Room end of the cables according to the
table below
Cable
Free length from the conduit exit
PIM cable
2.4 m (8 ’)
Control Station cable
2.1 m (7 ’)
Joystick cable
2.7 m (9 ’ )
ECG cable
Depends on the ECG location
NOTE: The incorrect cable length might cause reliability issues during the operation !
Make sure, that the out of conduit parts of the cables with the connectors are properly protected
during the rest of the installation
Innova 2100-IQ, 3100/3100-IQ, 4100/4100-IQ Cardiovascular Imaging System Pre-Installation Manual
GE Healthcare Direction 5160944-13-1EN, Revision 2
Chapter 6 Electrical Connections 185

Table of Contents

Related product manuals