32
Cleaning the glass cooktop. (on some models)
Operating
Instructions
Safety InstructionsCare and Cleaning
Installation
Instructions
Troubleshooting Tips
Consumer Support
Allow the cooktop to cool.
Use a single-edge razor blade
scraper at approximately a 45° angle
against the glass surface and scrape
the soil. It will be necessary to apply
pressure to the razor scraper in
order to remove the residue.
After scraping with the razor
scraper, spread a few drops of
CERAMA BRYTE
®
Ceramic Cooktop
Cleaner on the entire burned residue
area. Use the CERAMA BRYTE
®
Cleaning Pad to remove any
remaining residue.
For additional protection,
after all residue has been removed,
polish the entire surface with
CERAMA BRYTE
®
Ceramic Cooktop
Cleaner and a paper towel.
Burned-On Residue
WARNING: DAMAGE to your glass surface may
occur if you use scrub pads other than those
recommended.
Allow the cooktop to cool.
Spread a few drops of CERAMA
BRYTE
®
Ceramic Cooktop Cleaner
on the entire burned residue area.
Using the included CERAMA
BRYTE
®
Cleaning Pad for Ceramic
Cooktops, rub the residue area,
applying pressure as needed.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after
all residue has been removed, polish
the entire surface with CERAMA
BRYTE
®
Ceramic Cooktop Cleaner
and a paper towel.
The CERAMA BRYTE
®
Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts Center.
See instructions under “To Order
Parts” section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
Use a CERAMA BRYTE
®
Cleaning
Pad for Ceramic Cooktops.
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE
®
Ceramic
Cooktop Cleaner on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of your
glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with CERAMA
BRYTE
®
Ceramic Cooktop Cleaner.
This helps protect the top and makes
cleanup easier.
Daily use of CERAMA BRYTE
®
Ceramic Cooktop Cleaner will help
keep the cooktop looking new.
Shake the cleaning cream well. Apply
a few drops of CERAMA BRYTE
®
Ceramic Cooktop Cleaner directly to
the cooktop.
Use a paper towel or CERAMA
BRYTE
®
Cleaning Pad for Ceramic
Cooktops to clean the entire cooktop
surface.
Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO NOT heat
the cooktop until it has been cleaned thoroughly.
Clean your cooktop after
each spill. Use CERAMA
BRYTE
®
Ceramic Cooktop
Cleaner.
To Next Page
Loading...
Need help?
General
