GE JBP24 Use And Care & Installation Guide

US~G YOUROWN
BeforeUsingYourOven
1. Look at the controls. Be sure you understand how to 3. Read over the information and tips that follow.
set them properly.
4. Keep this guide handy so you can refer to it,
2. Check the oven interior. Look at the shelves. Take especially during the first weeks of using your
a practice run at removing and replacing them new range,
properly to give sure, sturdy support.
OvenShelves
The shelves are designed with stop-locks so that
when placed correctly on the shelf supports, they
will stop before coming completely out from the
oven, and will not tilt when removing food from or
placing food on them.
When placing cookware on a shelf, pull the shelf out
to the bump on the shelf support. Place the cookware
on the shelf, then slide the shelf back into the oven.
This will eliminate reaching into the hot oven.
To remove a shelf from the oven, pull it towards you,
tilt the front end upward and pull it out.
To replace, place
Bump
the shelf on the shelf
support with the
stop-locks (curved
h
-~iA
extension under the
shel~ facing up toward ~-”
the rear of the oven. ~
Tilt up the front and ~
push the shelf toward ‘=
1111
the back of the oven
until it goes past the
-/11
bump on the shelf support.
Then lower the front of the
shelf and push it all the way back.
ShelfPositions
The oven has 4 shelf supports as identified in
this illustration as A (bottom), B, C and D (top).
Shelf positions for cooking food are suggested
1
+411
in the Baking, Roasting and Broiling sections.
~L -
d II
OvenLight(on some models)
AutomaticOvenShut Off
The light comes on automatically when the oven
As a safety feature, this oven will automatically shut
door is opened.
itself off after 12hours. On models with touch pad
On models with an oven window, use the switch to
clock controls this feature may be deactivated to allow
turn the light on and off when the door is closed.
the oven to be left on for more than 12hours.
To deactivate the Automatic Oven Shut-Off, press and
hold both the increase and decrease minute pads for
about 4 seconds. The display will change from time of
day to show “off’.
To reactivate the feature, press and hold both the
increase and the decrease minute pads for about 4
seconds. The display will change from time of day to
show “on”.
12

GE JBP24 Specifications

General

Brand	GE
Model	JBP24
Category	Ranges
Language	English