GE JBP85 - Using the Clock and Timer

Usingthe clock and timer.
Make surethe clockisset to the
correcttimeofda)_
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
[] Touch the CLOCKpad.
[] Touch the number pads.
[] Touch the STARTpad until the
time of day shows in the display.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes,
To Set the Timer
[] Touch the KITCHENTIMER
ON/OFFpad.
[] Touch the number pads until the
amount of time you want shows in
the display. For example, to set 2
hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake touch the KITCHENTIMER
0N/0FF pad and begin again.
[] Touch the STARTpad.
r_] When the timerreaches .'O0,the
"L2--J
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHENTIMER0N/0FF pad
is touched.
The6 secondtonecanbecanceledby following
thestepsin theSpecialfeaturesof youroven
controlsectionunderTonesat theEndofa
TimedCycle.
ToReset the Timer
If the display isstill showing the time
remaining, you may change it by
touching the KIIBHENTIMEROIg,'OFFpad,
then touch the number pads until the
time you want appears in the display.
If the remaining time is notin the display
(dock, delay start or cooking time are in
the display), recall the remaining time by
touching the KITCHENTIMER0N/0FFpad
and then touching the number pads to
enter the new time you wanL
To Cancel the Timer
Touch the KITCHENTIMERON/OFF
pad twice.
/6