Cook and Hold
Your new control has a cook and hold feature that
keeps cooked foods warm for up to 3 hours after
the cooking function is finished.
To activate this feature, follow the steps
below.
Touch the
BAKE
and
BROIL HI/LO
pads at the same time for 3 seconds
until the display shows
SF.
Touch the
COOKING TIME
pad.
The display will show
Hld OFF.
Touch the
COOKING TIME
pad again
to activate the feature. The display
will show
Hld ON.
Touch the
START
pad to activate
the cook and hold feature and
leave the control set in this special
features mode.
Using Convection Conversion
By using the Convection Conversion feature you
can automatically convert the oven temperature
from regular baking to Convection Bake
temperatures.
To convert the oven temperature for
convection baking, follow the steps below.
Touch and hold the
CONVECTION
BAKE/ROAST
pad for 4 to 5 seconds.
Using the number pads, enter
the temperature recommended
in the recipe.
Touch the
START
pad.
The display shows the converted
(reduced) temperature. For
example, if you entered a recipe
temperature of 350°F, the display
will show
325°F.
when it is converted.
Touch the
CLEAR/OFF
pad when
baking is finished.
NOTE: Conversion must be set each time
you want to use it. It is not held in memory.
Conversion is used on Convection Bake only.
12
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Special features of your oven control.
12 Hour, 24 Hour or Clock Black-Out
Your control is set to use a 12 hour clock.
If you would prefer to have a 24 hour
military time clock or black-out the clock
display, follow the steps below.
Touch the
BAKE
and
BROIL HI/LO
pads at the same time for 3 seconds
until the display shows
SF.
Touch the
CLOCK
pad once. The
display will show
12 hr.
If this is
the choice you want, touch the
START
pad.
Touch the
CLOCK
pad again to change
to the 24 hour military time clock. The
display will show
24 hr.
If this is the choice
you want, touch the
START
pad.
Touch the
CLOCK
pad again to black-out
the clock display. The display will show
OFF.
If this is the choice you want, touch
the
START
pad.
NOTE: If the clock is in the black-out mode you
will not be able to use the Delay Start function.
To Next Page
Loading...
