C-4 F650 Digital Bay Controller GEK-113000T
C.1 FACTORY DEFAULT SETTINGS APPENDIX C
C
PRODUCT SETUP>COMMUNICATION SETTINGS >IEC 870-5-104
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Enable or disable the protocol
operation
Function DISABLED N/A [DISABLED – ENABLED]
Listening TCP port in the relay TCP Port 2404 N/A [0 : 65535]
Address in the ASDU header
Common Addr of
ASDU
255 N/A [0 : 65535]
Number of seconds for instantaneous
metering
Cyclic Meter Period 0 1 s [0 : 3600]
Not implemented Synchronization Event 0 N/A [0 : 3600]
IEC 870-5-104 NOTES
Note 1: Cyclic Meter Period 0 value means no spontaneous metering
PRODUCT SETUP>COMMUNICATION SETTINGS > SNTP
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Function permission Function DISABLED N/A [DISABLED – ENABLED]
Port used UDP port 123 1 [1 : 65535]
IP Address OCT 1 Server IP Oct 1 0 1 [1 : 255]
IP Address OCT 2 Server IP Oct 2 0 1 [1 : 255]
IP Address OCT 3 Server IP Oct 3 0 1 [1 : 255]
IP Address OCT 4 Server IP Oct 4 0 1 [1 : 255]
PRODUCT SETUP>COMMUNICATION SETTINGS >PROCOME
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Serial Remote Com Port selection COMM Port NONE [NONE – COM1]
Slave number for procome Slave Number 0 [0 : 254]
To Next Page
Loading...
