GE Multilin F650 - Page 230

GEK-113000T F650 Digital Bay Controller C-5
APPENDIX C C.1 FACTORY DEFAULT SETTINGS
C
SETPOINT > PRODUCT SETUP > MODBUS USER MAP
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Address 00 for Modbus user map Address 00 0 N/A [0000 : FFFF]
Address 01 for Modbus user map Address 01 0 N/A [0000 : FFFF]
... ... ...
Address 254 for Modbus user map Address 254 0 N/A [0000 : FFFF]
Address 255 for Modbus user map Address 255 0 N/A [0000 : FFFF]
SETPOINT > PRODUCT SETUP > FAULT REPORT
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Function permission Function DISABLED N/A [DISABLED – ENABLED]
Positive sequence impedance module Pos Seq Module 3.00 0.01 Ohm [0.01 : 250.00]
Positive sequence impedance angle Pos Seq Angle 75 1 Deg [25 : 90]
Zero sequence impedance module Zero Seq Module 9.00 0.01 Ohm [0.01 : 750.00]
Zero sequence impedance angle Zero Seq Angle 75 1 Deg [25 : 90]
Line length Line Length 100.0 0.1 [0.0 : 2000.0]
Display fault on HMI Show Fault On HMI DISABLED N/A [DISABLED – ENABLED]
Snapshot Event generation Snapshot Events ENABLED N/A [DISABLED – ENABLED]
SETPOINT > PRODUCT SETUP > OSCILLOGRAPHY
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Function Permission Function ENABLED N/A [DISABLED – ENABLED]
Prefault Trigger Position 30 1% [5 : 95]
Samples per cycle Samples/Cycle 64 N/A [4 – 8 – 16 –32 – 64]
Maximum number of oscillos Max. Number Osc. 4 1 oscillo [1 : 20]
Automatic oscillography overwrite Automatic Overwrite DISABLED N/A [DISABLED – ENABLED]
Snapshot Event generation Snapshot Events ENABLED N/A [DISABLED – ENABLED]
SETPOINT > PRODUCT SETUP > DATA LOGGER
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Function permission Function DISABLED N/A [DISABLED – ENABLED]
Data logger Rate Data Logger Rate 1 s N/A
[1 s, 5 min, 10 min, 15 min,
20 min, 30 min, 60 min.]
Data Logger analog channels X Data Logger Chnl X None N/A [1 to 16]