Page 15
OTHER KEYPAD FUNCTIONS
SETTING THE KEYPAD TONE
Step 1 Press [r]-[0]. Keypad is now in the “Adjust Tone” mode.
Step 2 Pressing the [•] key will make the keypad sounder go to higher
tones, pressing the [–] key will make the keypad sounder go to
lower tones.
Step 3 When the desired tone is reached, press the [#] key to set this
tone and exit from the “Adjust Tone” mode.
CHANGE PARTITION – Optional
Step 1 Press [r]-[1].
Step 2 Press a NUMBER key between 1 and 8 to change partitions
momentarily.
Step 3 If no other key is pressed, it will go back to its standard partition
in ten seconds.
Step 4 If another key is pressed, the system will remain in the new
partition until no keys have been pressed for 60 seconds.
VIEW ALARM MEMORY
Step 1 Press [r]-[3]. The zone(s) that created the last alarm will be
displayed on the keypad.
Step 2 The ALARM MEMORY feature will flash those zones that created
alarms and will light steady those zones that were bypassed
during the last alarm.
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator test,
and/or a siren test. Alarms and reports will not
be sent, unless a
communicator test is performed at which time a test signal will be sent.
Step 1 Press [r]-[4]. The test will be performed as programmed.
Step 2 If the siren test is performed, enter a user code to silence the
siren.
To Next Page
Loading...
