Page 16
RESET FUNCTION
This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers. Your system must be Disarmed to use the Reset function.
Step 1 Press [r]-[7]. Resets have now been performed.
Step 2 If the keypad begins beeping, the reset did not execute properly.
Enter your code to silence the keypad. Wait a few minutes and
repeat step 2 to attempt another reset. If the keypad still beeps
after repeated attempts, please contact your installer.
SET SYSTEM DATE
Step 1 Press the [r]-[9]-[6]-[“Master Code”].
Step 2 Enter the “Day of Week “
1=Sunday 3=Tuesday 5=Thursday 7=Saturday
2=Monday 4=Wednesday 6=Friday
Step 3 Enter the “Month Code”. Must always be two (2) digits.
01 = January 05 = May 09 = September
02 = February 06 = June 10 = October
03 = March 07 = July 11 = November
04 = April 08 = August 12 = December
Step 4 Enter the “Day Code”. Must always be two (2) digits.
Example: The 5
th
would be entered as [0]–[5].
Step 5 Enter the last two digits of the “Year Code”.
Example: For 1997 enter [9]–[7].
SETTING THE SYSTEM CLOCK
Step 1 Press [r]-[9]-[7]-[“Master Code”].
Step 2 Enter the “hour code” which must be two (2) digits. Note: The
clock is a 24-hour clock. Refer to the following table.
Step 3 Enter the “minutes code” which must be two (2) digits.
Example: 7 minutes after would be entered [0]–[7].
To Next Page
Loading...
