GE NetworX NX-8E User Manual

9
KEYPAD FUNCTIONS
ARMING YOUR SYSTEM IN THE “AWAY” MODE
AWAY is used when the user is away from the premise and wants the interior
protected. Listed below are the steps to arm in the AWAY Mode:
Step 1
Close all protected doors and windows.
• Ready light will be on or flashing when all protected zone
s and
sensors are secure.
NOTE: If any zones are bypassed, a sensor
in that zone can be violated without affecting the ready light.
• The security system will not arm if the ready light
is not on or
flashing.
• If the power light is off, you have no AC po
wer. Restore power if
possible. If not, contact your installing company listed on page 1 of
this booklet for service.
Step 2
• Enter your 4 or 6 digit user code to arm the system.
• The armed and exit lights will illuminate.
• You may now leave the building.
Note: The exit light will flash rapidly for the last 10 seconds of the exit delay
as a warning to the user that the exit time is about to expire. The user may
wish to disarm and rearm the system if more time is needed.
ARMING YOUR SYSTEM IN THE “STAY” MODE
STAY is used when the user is inside the premise and wants protection around
the perimeter. Listed below are the steps to arm in the STAY Mode:
Step 1 Close all protected doors and windows.
• Ready light must be on or flashing when all protected zon
es and
sensors are secure.
NOTE: If any zones are bypassed, a sensor
in that zone can be violated without affecting the ready light.
• The security system will not arm if the ready light
is not on or
flashing.
• If the power light is off, you have no AC p
ower. Restore power if
possible. If not, contact your installing company listed on page 1 of
this booklet for service.
Step 2
• Enter your 4 or 6 digit user code.
• If “Auto Bypass”
is enabled, all interior zones will be bypassed if you
do not leave through a designated entry/exit door.
If Auto Bypass is
enabled, omit Step 3.
• When “Auto Instant” is enabled,
if you do not leave through a
designated entry/exit door the instant light
will illuminate indicating
that the entry/exit doors no longer have an entry delay. If “
Auto
Instant” is enabled, omit Step 4.
Step 3
• Press the [STAY] key.
• The stay light
will illuminate indicating that all interior zones are

GE NetworX NX-8E Specifications

General

Brand	GE
Model	NetworX NX-8E
Category	Control Panel
Language	English