NX-10 User Manual 35
Installer The person who installs and programs
the system.
Keypad sounder An audible signal that is sounded by the
keypad. This can be programmed to
sound at various times.
Master Code A menu option that assigns a master
code to the selected user. This is an arm/
disarm code that can program other
user codes provided it has access to the
same partitions as the user code.
Master mode The mode in which a control panel can
arm multiple partitions.
Outputs A menu option that sets a user’s rights to
control the control panel’s auxiliary out-
puts. These outputs must be pro-
grammed by the installer.
Problem zone A zone that prevents the system being
armed. A problem zone typically has an
open window or door (open zone) or a
tamper has occured on the zone (tamper
zone).
Reports Open/Close A menu option that sets the code of the
selected user to report arms (close) and
disarms (open).
Sensor A device that detects violations and re-
ports them to the control panel. Sensors
include door and window contacts or any
device used to inform the control panel of
a particular condition.
Single-partition mode The mode in which a control panel can
arm one partition only.
Tamper Interference with the system such as an
open casing.
Up/download Management software that can read the
software system programming informa-
tion (upload) or modify or replace the sys-
tem information if necessary (download).
User Authority A menu option that displays user rights.
User code A four or six digit code used to arm or dis-
arm the system and access the User
menu.
Wireless zone A sensor that transmits to the control pan-
el via a radio receiver rather than being
directly wired to the control panel.
Zone An partition guarded by a group of one or
more detection devices.
Glossary
To Next Page
Loading...
Need help?
General
