GE Optima XR220amx - Chapter 1 General Requirements; Section 1.1 Objectives and Overview; Pre-Installation Tasks

GE HEALTHCARE OPTIMA XR200AMX/XR220AMX
D
IRECTION 5336112-1EN, REVISION 3PRE-INSTALLATION MANUAL
Chapter 1 General requirements Page 17
Chapter 1 General requirements
Section 1.1 Objectives and overview
This document is intended as a guide and informational resource for planning and properly
preparing a location for the installation of the Optima XR200amx/XR220amx system.
To avoid unnecessary expenses and delays, be sure to review all the information in this manual to
determine whether the site is ready for the installation to begin. This is an important process that
helps verify site readiness.
1.1.1 Pre-installation tasks
Pre-installation is a cooperative effort between the customer/purchaser and GE Healthcare. The
diagram below shows the pre-installation process.
Planning and
site work
complete?
Chapter 2 Special
construction requirements
Chapter 3 Environmental
(HVAC) requirements
Chapter 4 Electrical
requirements
Chapter 6 Network /
workflow information
Pre-installation
site work
Site planning
Site data
collected from
field
Radiation
consultant
Chapter 5 Communication
requirements
No
Yes
Delivery and
installation