GE Optima XR220amx - Chapter 6 Network; Workflow Information; Section 6.1 Network;Workflow Information; Facility Information; Physical Network

GE HEALTHCARE OPTIMA XR200AMX/XR220AMX
D
IRECTION 5336112-1EN, REVISION 3PRE-INSTALLATION MANUAL
Chapter 6 Network / workflow information Page 33
Chapter 6 Network / workflow information
Section 6.1 Network/workflow information
This section contains questions designed to elicit necessary information about DICOM equipment,
workflow, and dataflow. The information collected here is required for GE Healthcare employees to
install the equipment and to connect it to the site's wired and wireless networks.
6.1.1 Facility information
Name of facility: _______________________________________________________________
Workflow contact: ____________________________________ Phone: __________________
Wired network contact:________________________________ Phone: __________________
Wireless network contact:______________________________ Phone: __________________
DICOM device contact: ________________________________ Phone: __________________
Other contact: _______________________________________ Phone: __________________
6.1.2 Physical network
Network infrastructure
What wired networks and/or wireless uplinks does this facility use?
 Has 100/1000 Base-T installed
 Will have 100/1000 Base-T installed by this date:___________
 Has 10 Base-T installed
 Will have 10 Base-T installed by this date: ___________
 Has a different network installed: _____________________
 If FIPS is enabled: _____________________
 Does not have a network installed
Wireless network standards
What wireless network standard is the site using?
 IEEE 802.11a
 IEEE 802.11b/g
 IEEE 802.11n