What to do if the display does not function on my GE Medical Equipment?
If the display of your GE Medical Equipment isn't working, try these steps: First, unplug the display power cord and the display cable, ensure they are intact, and then reconnect them. Next, unplug the Monitor-LCD Display cable, verify its condition, and reconnect it. Finally, check if the display brightness is properly adjusted.
How to troubleshoot GE Medical Equipment when nothing functions?
If your GE Medical Equipment isn't functioning at all, try these steps: Unplug the Command Bar or Remote Controller cable, ensure it's intact, and then reconnect it. Next, unplug the power cord, check that it is intact, and reconnect it. Finally, verify that the fuses are intact.
What to do if the Airway Module does not function on GE Medical Equipment?
If the Airway Module on your GE Medical Equipment isn't working, make sure that the ‘Occlusion’ or ‘Calibrating Gas Sensor’ messages are not displayed. Verify that a D-fend water trap and a sampling line are properly attached. Ensure the Gas Interface Board, B-GAS is correctly inserted. Check if the parameters displayed are configured correctly. Press and hold the Select Agent key for three seconds. Turn off the power to the Central Unit. Unplug the Gas Interface Cable, check that the cable is intact, then reconnect the cable. Finally, turn the power back on to the Central Unit.
What to do if a parameter module does not function on GE Medical Equipment?
If a parameter module on your GE Medical Equipment isn't functioning, try removing and replacing the module. Also, ensure that the displayed parameters are configured correctly.
How to fix a Compact Airway Module that does not function on GE Medical Equipment?
If the Compact Airway Module on your GE Medical Equipment isn't working, try removing and replacing the module.
General| Brand | GE |
|---|---|
| Model | Datex-Ohmeda S/5 |
| Category | Medical Equipment |
| Language | English |
To Next Page