GE Datex-Ohmeda S/5 - Connectors and Signals; Leds

Datex-Ohmeda S/5
TM
Anesthesia and Critical Care Monitors
4
Document no. M1125639-03
2.1.4 LEDs
The alarm LEDs are activated by the Command Bar PCB under the commands received via
serial communication from the CPU board. The red or yellow alarm LED is lit, when the red or
yellow alarm is activated. The green STBY led is lit, when the device is turned to stand-by and
connected to the mains.
NOTE: If there are two Command Bars connected to the system, the system is ON (STBY LED not
lit), when at least one of the switches is positioned ON.
2.1.5 Connectors and signals
Table 1 26-pin D-connector on K-ANEB/K-ICUB
Pin No I/O Signal
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
I
I
O
O
I
Not connected
Not connected
Not connected
Not connected
Not connected
GND
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
+5 V
ON/STBY
Not connected
Not connected
TXDD RS232
RXDD RS232
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected