Datex-Ohmeda S/5 Anesthesia and Critical Care Monitors
6
Document no. M1125637-04
2.2 Ethernet interface
The data transformer is designed by Datex-Ohmeda and it is hospital grade approved.
Adapter’s 10BASE-T is an interface with 7-pole butterworth low-pass filters on the unisolated
side of the transformer. There is a common mode choke on the isolated side for both
transmitting and receiving lines.
There are also two LEDs on the board, which are not visible from the outside, indicating the
following:
2.3 Software License
The upgrade software has been developed for monitor software upgrades. The upgrade
software can be downloaded onto a monitor that is equipped with the B-CPU6.
The service software has been developed to replace the original monitor software in case of a
B-CPU6 failure. There is service software available for each S/5 monitor software version. The
functionality of the service software is equal to the functionality of the corresponding original
S/5 monitor software.
The Service License and Upgrade License is license software. The license agreement that is
delivered with the software should be archived in a secure location. Relevant license number
may have to be referred when contacting GE Healthcare for service/support. The licence
number is needed also for possible software upgrades.
- link/activity H3 Yellow
- speed H4 Green
To Next Page
Loading...
