System installation
35
Document no. M1137263-04
WARNING The displays must only be used together with the original type of power
adapter.
CAUTION The LCD displays are fragile. Ensure that the LCD displays are not placed near a
heat source or exposed to mechanical shocks, pressure, moisture, or direct
sunlight.
3.5.5 15” Flat Panel Display, D-FPD15
Mounting to Central Unit
Connect the video cable and power adapter cable to the 15” Flat Panel Display, D-FPD15.
Tighten the video cable finger screws. Attach the Command Bar, K-ANEB / K-ICUB into the
keypad holder.
Mount the display together with the desk stand to the Central Unit using the display alignment
studs on the top of the frame (applies to Central Unit, F-CU8 only).
Mounting
Mount the 15” Flat Panel Display, D-FPD15, to a pedestal, wall or ceiling mount, or to a display
arm with appropriate parts.
Connection to Central Unit
1. Make sure that power to the Central Unit is turned off.
2. Remove the connector cover: Press “fixed lever” downward on the back of the display.
Then slip the cover to the direction of the arrow and remove the cover.
3. Connect the AC adapter’s DC plug into the displays power input. Connect the provided
power cord in to the inlet of the auxiliary AC adapter. Then, connect plug to the mains
outlet.
4. Connect the DVI cable to the connector X2 on the CPU board, B-CPU6. Alternatively,
connect the VGA cable to the connector X2 on the CPU board, B-CPU6. Tighten the finger
screws.
WARNING The display must be used only together with the original D-FPD15 power
adapter.
Adjustments
Switch the monitor on. Wait until the normal monitoring screen appears. Perform the following
adjustments, if needed.
1. Resolution setting
Check that the picture on the LCD display screen is clear and stable. Check that the
display screen uses the XGA resolution.
To Next Page
Loading...
