GE Datex-Ohmeda S/5 - Introduction

S/5
TM
UPINET Board, B-UPI4NET-02
1
Document no. M1137269-02
Introduction
Datex-Ohmeda S/5 UPI4NET board, B-UPI4NET integrates the UPI board and the Network
Board, B-NET. Datex-Ohmeda S/5 UPI4 board, B-UPI4 is the same board as UPI4NET except it
does not contain network related components. However, when used together with B-CPU6, the
network portion of the board is handled by the B-CPU6 board. In such case, the network
connection on the B-UPI4NET front panel will be blocked.
The UPI4NET board provides interfaces for example for a computer, parallel printer and Device
Interfacing Solution (DIS). In addition, the board has two digital output signals and two analog
output signals for other interfaces.
The use of UPI4NET board requires S/5 Anesthesia or Critical Care main software.
The service menu is described in a separate “Service Menu“ slot and the spare part lists in the
“AM, CCM Spare Parts” slot.
Figure 1 UPINET Board, B-UPI4NET
NOTE: B-UPI4NET- 02 requires monitor software L-ANE06(A) / L-ICU06(A) or later.
NOTE: Updating the frame F-CU8 rev. 10 or earlier with B-UPI4NET-02 board will change the
CISPR class from B to A.