Datex-Ohmeda S/5 Anesthesia and Critical Care Monitors
42
Document no. M1137263-04
Connecting directly to the vacuum scavenging system
1. Connect the exhaust line to the monitor’s sample gas outlet.
2. Connect the exhaust line only to an open scavenging system where gas is removed at
room pressure. Do not connect the monitor directly to a vacuum scavenging system.
Returning sampling gas to the patient circuit
The sampling gas can also be returned to the patient circuit. If you use the S/5 Anesthesia
Delivery Unit (ADU), you need an optional adapter connected to the patient breathing tubes.
Take special care when returning sample gas to the patient circuit. For further information,
please contact your GE Healthcare distributor.
NOTE: If E-miniC is being used do not return the sample gas to the patient circuit
Figure 22 Sample gas returned to patient circuit in ADU
3.9 Record Keeping Keyboard for Anesthesia, K-ARKB
3.9.1 Connection to Central Unit
1. Make sure that the power to the Central Unit is turned off.
2. Connect the keyboard-monitor cable to the X2 connector on the Keyboard Interface
Board, B-ARK, and to the connector on the rear of the keyboard. Alternatively you can
connect the cable to a Display Controller Board, B-DISPX. Secure the connection with the
thumbscrew and slip the cable beneath the fasteners.
3.9.2 Connection to LCD Display, D-LCC12A
1. Make sure that the power to the Central Unit is turned off.
2. Connect the Keyboard-LCD Display Cable to the K-ARKB connector on the LCD Display
and to the connector on the rear of the keyboard. Secure the connection with the
thumbscrew and slip the cable beneath the fasteners.
SAMPLE GAS OUT
SCAVENGING
To Next Page
Loading...
