GE Datex-Ohmeda S/5 - Inserting the Parameter Modules

System installation
31
Document no. M1137263-04
If necessary, change the monitor's network communication by selecting DRI Level and
turning the ComWheel.
NOTE: If the DRI level is changed, the monitor will restart automatically.
6. Confirm that the network symbol and 'Connected to Network' message are displayed on
the upper part of the screen.
3.4.4 Inserting the parameter modules
1. Ensure that the module is properly orientated (i.e. module release latch facing downward).
2. Align the module insertion guide slot with the frame insertion guide.
3. Push the module into the frame until it clicks.
NOTE: Do not use two or more parameter modules with identical functions in the monitor
system. Take special care not to do this when using two F-CU5(P) module frames.
Inserting PSM modules
1. Align the module with the insertion guides.
2. Push the module into the monitor frame until it stops.
3. Pull the module outwards. Make sure not to drop it when it comes out.