Functional check
63
Document no. M1137263-04
5 Functional check
These instructions include procedures for a functional check for Datex-Ohmeda S/5 Anesthesia
Monitor and S/5 Critical Care Monitor. The functional check is mandatory after monitor
installation.
These instructions include a “Functional check form, Datex-Ohmeda S/5 AM, CCM” which may
be used when performing the procedures. The symbol
" in the instructions indicates that
the check form contains space to record the results of the particular procedure. The
procedures should be performed in ascending order, bypassing those that are not applicable
for a particular monitor.
All menu selections related to Datex-Ohmeda products are written in following typeface:
e.g. Parameters - Gas Unit.
As you enter the service menus, you need the following passwords:
Monitor Setup - Install/Service (password 16-4-34) - Service (password 26-23-8)
In case you evaluate the measurement accuracy with a patient simulator, add simulator’s
accuracy specification to the one of the monitor.
An electrical safety check and a leakage current test are recommended to be performed prior
to the monitor installation.
5.1 Recommended tools
NOTE: Use only properly maintained, calibrated and traceable measurement equipment for the
specified calibrations and adjustments to ensure accuracy.
For product(s) Tool Order No.
Airway modules
Compact Airway Module,
E-CAiO(VX)
Calibration gas and regulator 755583/755534*
Compact Airway Module, E-COVX Calibration gas and regulator 755587/755534*
Compact Airway Module, E-CO(V) Calibration gas and regulator 755581/755534*
E-miniC Calibration gas and regulator 755580/755534*
Compact Airway Module, E-COVX,
E-CAiOVX
Sampling line, 2 m 73318
All Airway modules w/ (V) Spirometry tube, 2 m 890031
D-lite 733950
Hemodynamic modules
Hemodynamic modules w/ (P) NIBP cuff and hose 2753E (cuff)
877235 (hose)
Pressure manometer
Hemodynamic modules w/
(P)E-PSMP
InvBP transducer 70077-001
To Next Page
Loading...
