GE Datex-Ohmeda S/5 - Figure 10 Rear View and Positioning, F-CU8 (-12 Shown); Positioning PC Boards

Datex-Ohmeda S/5 Anesthesia and Critical Care Monitors
26
Document no. M1137263-04
Pole mount for PSM – Instructions for connecting to frame
3.3.5 Positioning PC boards
Figure 10 Rear view and positioning, F-CU8 (-12 shown)
(1) Mains power inlet
(2) Battery 24 Vde input connector (F-CU8 - 12) / Display power outlet (F-CU8 rev. 03 to 09)
(3) UPINET Board, B-UPI4NET
(4) B-CPU6 and integrated display controller (primary/screen1)
(5) Display Controller Board, B-DISPX (secondary/screen 2)
Display Controller Board, B-DISPX (3
rd
screen), Keyboard Interface Board, B-ARK
(6) Service reset button
(7) Equipotential connector
1. Attach the E-PSM(P) module to the Pole Mount.
2. Connect the cable of the Pole Mount for PSM to the F-CU8
with the E-INTPSM module (M1054424).
3. Check the module communication of the E-PSM(P)
module.
1. Attach the E-PSM(P) module to the Pole Mount.
2. Connect the cable of the Pole Mount for PSM to the S/5
F-CU5 with the Module Bus adapter for PSM (M1031025).
3. Check the module communication of the E-PSM(P)
module.
2
!
1
8
5
9
3
4
6
7
3
4
1
2
7
6
5