GE Datex-Ohmeda S/5 - E-PSM(P) Mounting Accessories; Figure 9 E-PSM(P) Mounting Accessories

Datex-Ohmeda S/5 Anesthesia and Critical Care Monitors
24
Document no. M1137263-04
3.3.4 E-PSM(P) Mounting Accessories
Intended use
The Frame Mount for PSM and the Pole Mount for PSM, short and long, are intended to be used
with the stationary docking station of the E-PSM(P) module. The Interface Module for PSM,
E-INTPSM, is intended for connecting the Frame Mount and the Pole Mount to the
Datex-Ohmeda S/5 F-CU8.
The Module Bus Adapter for PSM is intended for connecting the Pole Mount for PSM to the
Datex-Ohmeda S/5 F-CU5 frame.
The Frame Mount for PSM can be attached directly to the F-CU8. The Pole Mount for PSM, short
or long, can be attached to an IV pole or to an anesthesia machine rail with a diameter of
10mm* 25mm.
With Interface Module for PSM, E-INTPSM, the Frame Mount or the Pole Mount can be
connected to the Datex-Ohmeda S/5 F-CU8 frame equipped with software license 04 or later.
The E-PSM(P) module can be attached to the Frame Mount or Pole Mount and used like a
Datex-Ohmeda S/5 modular module.
With Module Bus Adapter, the Pole Mount for PSM, short or long, can be connected to the
Datex-Ohmeda S/5 F-CU5 frame. The E-PSM(P) module can be removed from the F-CU5 frame
and docked to the Pole Mount for PSM, short or long.
Figure 9 E-PSM(P) mounting accessories
1. M1054424 Interface Module for PSM, E-INTPSM
2. M1051025 Module Bus Adapter for PSM
3. M1051021 Frame Mount for PSM
4. M1049197 Pole Mount for PSM, short
5. M1051023 Pole Mount for PSM, long
2
1
5
3
4