GE Datex-Ohmeda S/5 - Visual Inspection

S/5
TM
8-Module Frame, F-CU8 -12
13
Document no. M1125635-05
3.2.3 Visual inspection
Make sure that no cables or modules are connected to the Central Unit. Lift off the Video
display with its stand, if placed on the Central Unit.
8-Module Frame, F-CU8
1. Bronze taps
Check that the two bronze taps on the frame are tightened properly.
"
2. Pads and screws
Turn the frame onto one of its sides. Check that all the four rubber pads are in place and
the screws on the bottom are tightened properly.
"
3. Module motherboard connectors
Turn the frame back to its normal position.
Check that the module motherboard connectors are clean and intact. Check also that the
screws that connect the module mother board to the frame are tightened properly.
"
4. Module motherboard position
Check that the E-REC fits in smoothly and locks up properly in all possible slots in the
Central Unit. Leave the E-REC disconnected.
"
CAUTION Ensure that the module is properly orientated (i.e. module release latch facing
downward) before insertion.
Power supply unit
5. Fan filter
Clean or replace the fan filter.
"
6. Primary fuses
Disconnect the primary fuse holder. Check that the fuse compartment, the fuse holder
and the fuses are clean and intact. Check also that the fuses are of the correct rating.
Reconnect the fuse holder and check that it locks up properly.
"
7. Power inlet connectors
Check that the power inlet connectors are clean and intact.
"