GE Datex-Ohmeda S/5 - Appendix A: Service Check Form, Datex-Ohmeda 8-Module Frame, F-CU8

Appendix A, Service check form, Datex-Ohmeda 8-Module Frame, F-CU8
A-1(2)
Document no. M1125635-05
APPENDIX A: Service check form,
Datex-Ohmeda 8-Module Frame, F-CU8
OK = Test OK N.A. = Test not applicable Fail = Test failed
Customer
Service
Module type S/N
Service engineer
Date
OK N.A. Fail OK N.A. Fail
1. Bronze taps 2. Pads and screws
3. Module motherboard
connectors
4. Module motherboard
position
5. Fan filter 6. Primary fuses
7. Power inlet connectors 8. Service reset -switch
9. Equipotential tap and
rear panel screws
10. PC board screws
11. PC board connectors 12. Block screws for cables
13. Grounding plates
14. Optional display
controller board B-DISPX
jumpers/DIP switches
Notes
15. Communication lines
+Reset RS485 (pin 1))
>10 Ω
-Data RS485 (pin 5))
>10 Ω
+Data RS485 (pin 6)
>10 Ω
-Reset RS485 (pin 8)
>10 Ω