GE P50 Agile P253 - Page 67

P50 Agile P253
5 Configuration
P253/EN M/C
5-27
Overcurrent
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Overcurrent can be Enabled /
Disabled.
Neg Sequence O/C
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Neg Sequence O/C can be Enabled /
Disabled.
Earth Fault 1
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Earth Fault 1 can be Enabled /
Disabled.
Earth Fault 2
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Earth Fault 2 can be Enabled /
Disabled.
Thermal Overload
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Thermal Overload can be Enabled /
Disabled.
Loss of Load
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Loss of Load can be Enabled /
Disabled.
CB Fail
Enabled
Editable setting
By using the (+ /5) or (- /6) key, CB Fail can be Enabled / Disabled.
Stall Detection
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Stall Detection can be Enabled /
Disabled.
Limit NB Starts
Enabled
Editable setting
By using the (+ /5) or (- /6) key, Limit NB Starts can be Enabled /
Disabled.
IFL
1.00
Editable setting
By using the (+ /5) or (- /6) key, the desired IFL (Full Load Current)
can be set. The setting range is 0.2 In – 4 In step 0.01 In